News — Load

Contractor cut joist hangers to make them fit

Beam Joists Load

Contractor cut joist hangers to make them fit

(edited with additional info re. header) We are removing a couple of load bearing walls as part of renos in our home. The engineer specified a W8x21steel beam to replace the load bearing wall. The floor joists are 2x10. It appears the contractor put the bolts into the "header" (not sure if that is the right term) in the wrong place (not enough space between bolt and joist). He then cut some of the joist hangers to make them fit. This has been done in at least 4 out of the 10 hangers that he has installed. Also, he used...

Read more →


Contractor cut joists short (followup to earlier question)

Beam Joists Load

Contractor cut joists short (followup to earlier question)

We are removing a couple of load bearing walls as part of renos in our home. The engineer specified a W8x21steel beam to replace the load bearing wall. The floor joists are 2x10. The joists are 2x10 and W Spruce. Their span is about 12' and are spaced 16" on center. The space above the joists is comprised of two bedrooms and 2 bathrooms (shower in one and tub in the other). The upper area is being renovated and bedrooms will have hardwood flooring (carpet previously) and tile in bathrooms. The contractor had originally put the bolts too close to...

Read more →